P1074464_wt.7z May 2026

If the standard feature fails (which often happens on complex surfaces like fenders or casting pockets), consider these professional workarounds:

: If a face is too complex, use a "Split Line" to break it into smaller segments before applying the draft to each part individually. p1074464_wt.7z

: Often used for more complex geometry, this method allows you to use a specific edge or curve as the split point for the draft. This is highly recommended for parts with non-planar divisions. If the standard feature fails (which often happens

: For extremely difficult geometry, copy the surfaces, apply the draft to those surfaces, trim them, and then "Solidify" them back into the main part. : For extremely difficult geometry, copy the surfaces,

: If a specific area requires no taper, try entering a value of "0" for the draft in that section to maintain verticality while drafting surrounding faces.