: Check the angle display at 20°, 45°, and 70°. The display must be within ±0.5 degrees of the inclinometer reading.
This guide covers the assembly and adjustment of core components found in the system's technical manuals. 1. Cable Reel & Length Sensor n_031.mp4
: Set the boom between 0 and 5 degrees. Use an inclinometer to verify the actual physical angle. : Check the angle display at 20°, 45°, and 70°
: If replacing the system chip, ensure the notch faces the correct direction to avoid frying the board. : If replacing the system chip, ensure the
These sensors transform hydraulic pressure into electrical signals to calculate load.
Detailed wiring diagrams and flowcharts can be found in the PAT DS350 Service Manual or via WIKA Mobile Control Support . LENGTH-ANGLE-RADIUS-LOAD INDICATING SYSTEM
: Ensure the hoist limit switch stops the winch before the hook hits the boom tip.