: Measure the opening in three places (top, middle, bottom for width; left, center, right for height).
: Screw the roller brackets to the top (and sometimes bottom) of the door panels, usually 1–1.5 inches from the side edges. Mount the Panels :
: Use a level or plumb line to ensure the side walls and floor are perfectly horizontal and vertical. instruktsiia po ustanovki dveri kupe
: This is usually the first piece installed. Cut it to the width of the opening using a hacksaw. Secure it to the top jamb or ceiling header using screws, ensuring it is perfectly level. Lower Track :
Installing sliding "coupe" doors (whether for a wardrobe or as an interior room divider) is a manageable DIY project that focuses on precise measurements and level tracks. 1. Preparatory Measurements Before installation, verify your opening dimensions. : Measure the opening in three places (top,
Angle the top into the rear groove of the upper track, then lower the bottom rollers into the rear groove of the bottom track. Repeat the process for the . 4. Final Adjustments
: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb. : This is usually the first piece installed
You can often secure the bottom track initially with or "liquid nails" to test the door movement before permanently screwing it into the floor.